Fire Protection — Data Center, Battery, Switchgear

Every application above shares the same failure pattern: an electrical fault ignites inside a sealed or semi-sealed enclosure, and suppression must act at the point of origin — before heat, smoke or flame reaches adjacent equipment. FIREQUELL's passive patches self-activate on thermal exposure (80°C, 140°C or 180°C grades), release FK-5-1-12 clean agent directly into the hazard zone, and leave no residue. No power supply, no detection panel, no pipework, and no scheduled servicing for the 5-year service life. For site-specific layouts, QuellWorks custom engineering maps patch coverage, activation grades and spacing to your enclosure geometry.

Electrical Panels

Low-voltage distribution cabinets, MCCs and switchboards where arc faults and cable faults concentrate. QuellPatch mounts directly on panel walls and cable entries — no pipework, no power.

Energy Storage

Lithium-ion battery cabinets, BESS containers and solar DC-side enclosures. QuellPatch and QuellCoat respond to thermal runaway within the enclosure, before fire spreads to adjacent racks.

Busbar Connections

Copper and aluminium busbar chambers and busway tap-off boxes, protecting joints and terminations that fail under sustained load.

Cable Trenches

Cable trays and cable management runs where low-voltage ignition can propagate along long lengths. Linear QuellPatch strips suppress at the point of origin, stopping spread to adjacent bundles.